構造体定義書 - arbelprm_query_fw

構文

Little Endian

struct arbelprm_query_fw_st

ファイル名

構造体情報

No.	名称	属性	説明
1	arbelprm_query_fw_st		Little Endian
	fw_rev_major[0x00010]	pseudo_bit_t	Firmware Revision - Major
	fw_pages[0x00010]	pseudo_bit_t	Amount of physical memory to be allocated for FW usage is in 4KByte pages.
	fw_rev_minor[0x00010]	pseudo_bit_t	Firmware Revision - Minor
	fw_rev_subminor[0x00010]	pseudo_bit_t	Firmware Sub-minor version (Patch level).
	cmd_interface_rev[0x00010]	pseudo_bit_t	Command Interface Interpreter Revision ID
	reserved0[0x0000e]	pseudo_bit_t
	wqe_h_mode[0x00001]	pseudo_bit_t	Hermon mode. If '1', then WQE and AV format is the advanced format
	zb_wq_cq[0x00001]	pseudo_bit_t	If '1', then ZB mode of WQ and CQ are enabled (i.e. real Memfree PRM is supported)
	log_max_outstanding_cmd[0x00008]	pseudo_bit_t	Log2 of the maximum number of commands the HCR can support simultaneously
	reserved1[0x00017]	pseudo_bit_t
	dt[0x00001]	pseudo_bit_t	Debug Trace Support
	cmd_interface_db[0x00001]	pseudo_bit_t	Set if the device accepts commands by means of special doorbells
	reserved2[0x0001f]	pseudo_bit_t
	reserved3[0x00060]	pseudo_bit_t
	clr_int_base_addr_h[0x00020]	pseudo_bit_t	Bits [63:32] of Clear interrupt register physical address.
	clr_int_base_addr_l[0x00020]	pseudo_bit_t	Bits [31:0] of Clear interrupt register physical address.
	reserved4[0x00040]	pseudo_bit_t
	error_buf_start_h[0x00020]	pseudo_bit_t	Read Only buffer for catastrophic error reports (physical address)
	error_buf_start_l[0x00020]	pseudo_bit_t	Read Only buffer for catastrophic error reports (physical address)
	error_buf_size[0x00020]	pseudo_bit_t	Size in words
	reserved5[0x00020]	pseudo_bit_t
	eq_arm_base_addr_h[0x00020]	pseudo_bit_t	Bits [63:32] of EQ Arm DBs physical address.
	eq_arm_base_addr_l[0x00020]	pseudo_bit_t	Bits [31:0] of EQ Arm DBs physical address.
	eq_set_ci_base_addr_h[0x00020]	pseudo_bit_t	Bits [63:32] of EQ Set CI DBs Table physical address.
	eq_set_ci_base_addr_l[0x00020]	pseudo_bit_t	Bits [31:0] of EQ Set CI DBs Table physical address.
	cmd_db_dw1[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 1 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw0[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 0 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw3[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 3 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw2[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 2 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw5[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 5 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw4[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 4 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw7[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 7 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_dw6[0x00010]	pseudo_bit_t	offset in bytes from cmd_db_addr_base where DWord 6 of a Command Interface Doorbell should be written. Valid only if CmdInterfa
	cmd_db_addr_base_h[0x00020]	pseudo_bit_t	High bits of cmd_db_addr_base, which cmd_db_dw offsets refer to. Valid only if CmdInterfaceDb bit is '1'
	cmd_db_addr_base_l[0x00020]	pseudo_bit_t	Low bits of cmd_db_addr_base, which cmd_db_dw offsets refer to. Valid only if CmdInterfaceDb bit is '1'
	reserved6[0x004c0]	pseudo_bit_t

arbelprm_query_fw_st

構文

ファイル名

構造体情報

See Also